TJM Pro Series Twin Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-31070
Page 11 of 23
23/02/2021
o
Drill the 6x base bracket mounting holes
with 8.5mm (for M8 bolts) and 2x for the
Vertical Wall Braces with 10.5mm (for M10
bolts). Do not drill greater than 9mm and
11mm holes respectivley.
o
It is recommended to first drill the marked
holes with a smaller pilot drill to ensure
hole position precision
o
All drilled holes and surrounding areas shall
be throughly cleaned of any metal swarf
from the drilling process.
o
All drilled holes shall be treated with a rust
proof treatment.
o
If mounting horizontally, place the
compressor in position over the drilled
holes. Use the supplied M8 Socket Button
Head Cap screws, M8 washers M8 Nyloc
nuts to secure the compressor on the
mounting panel. It is recommended to use
the supplied backing strips on the
underside of the panel for additional
rigidity.
o
If mounting the compressor in a vertical
configuration, first loosly secure the vertical
wall braces. Ensure that the 3 slots on each
of the Vertical Wall braces line up with with
the 6x drilled holes for the compressor
bracket.
o
Once the slots and holes line up, further
tighten the Vertical Wall Braces to limit
movement. Do not fully tighten at this
stage.
