TJM Pro Series Twin Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-31070
Page 23 of 23
23/02/2021
Serviceable Components
There are several serviceable components fitted to the compressor. These components include the
pressure switch, the copper connecting tube, compression fittings and relays. All these items are
located under the top cover.
NOTE:
It is recommended that all serviceable components be serviced by suitably qualified personnel
o
Ensure 5 Pin & 2 Pin Compressor plugs are
disconnected before removal of Top Cover.
o
Using a 4 mm hex key, remove the 6 x
M5 x 18 mm mounting screws and washers
between the compressor and Top Cover
(2 x front and 4 x rear).
o
Remove the top cover from the pair of
compressors using the hex key to assist in
lifting off the cover.
o
The components can now be accessed.
o
The assembly procedure is the reversal of the
assembly procedure. Ensure all brass crush
tubes and washers are used when re-
installing.
o
The major components of the compressor are
designed to be maintenance-free for the life
of the unit. The following parts are available
for servicing requirements:
013COMPVFILTER01 - Filter housing and element
combined kit
013COMPVFILTER02 - Filter housing kit to replace
housing only
013COMPVFILTER03 - Filter element kit
013COMPVACTSWITCH - Replacement activation
switch kit
013COMPVMOUNTKIT
–
Replacement rubber
isolator and bolt kit
013COMPVSRV155-18N
–
Safety relieve valve 155
PSI, male
⅛” NPT
013COMPVPS120-90
–
Pressure switch OFF 120
PSI / ON 90 PSI
