FITTING INSTRUCTIONS
Product:
T15 Signature Frontal Protection System
Vehicle:
Toyota HiLux (MY2020)
Part No.
070AP15N87J
For product warranty please refer to our website www.tjm.com.au
F-31649
Page 16 of 18
15/03/2021
56.
Use the indicated hole in the sliding washer
plate as a guide and drill an Ø8mm hole
through the mounts in both sides of the
vehicle. Keep the drill square to align with
holes in winch frame.
57.
De-burr all new edges, clean any swarf
from the areas and apply rust preventative
to exposed surfaces.
58.
Secure through the holes drilled in Previous
step using M8 x 1.25 x 35mm hex screws
(2), M8 x Ø19mm flat washers (4) & M8 x
1.25 nyloc nuts (2).
Tension the fasteners to the specified torque
settings listed on page 1.
59.
Insert M6 cage nuts (4) into each wing
guard, as shown opposite.
60.
Position the wing guard as shown, and
secure it in place.
60.1.
M6 x 1.0 x 20mm SS button head
bolts (4), M6 SS spring washers (4) &
M6 x Ø18mm SS flat washers (4).
60.2.
M8 x 1.25 x 25mm hex screw (2),
M8 spring washers (2), & M8 x 19mm
flat washer (2).
61.
Repeat on LHS.
RHS SHOWN
RHS SHOWN
1
2
