FITTING INSTRUCTIONS
Product:
T15 Signature Frontal Protection System
Vehicle:
Toyota HiLux (MY2020)
Part No.
070AP15N87J
For product warranty please refer to our website www.tjm.com.au
F-31649
Page 18 of 18
15/03/2021
64.
Remove the front bolts from OE underbody
guard and discard.
65.
Position the centre guard & loosely secure
the front edge using M6 x 1.0 x 20mm hex
bolts (3), M6 spring washers (3) &
M6 x Ø18mm flat washers (3).
66.
Fasten the rear with spacer (item 20)
positioned between centre guard and OE
under body guard using M8 x 1.25 x 40mm
hex bolt (2), M8 spring washer (2) &
M8 x Ø19mm flat washer (2).
67.
Tighten all guard fasteners to the relevant
torque settings listed on Page 1.
If a winch
was installed, torque its fasteners now.
68.
Using M6 x 1.0 x 20mm SS button head
bolts (2), M6 x Ø12.5mm SS flat washers (4)
& M6 SS nyloc nuts (2), secure the number-
plate in place, to the front of the FPS.
69.
Ensure that all of the fasteners are fully
tightened to the specified torque settings &
that, as a results of fitting the product, no
vehicle components are crushed or will
chafe.
