FITTING INSTRUCTIONS
Product:
T13 Outback Deluxe Frontal Protection System
Vehicle:
Holden Colorado 2016+
Part No.
070SB13L32R
For product warranty, please refer to our website, www.tjm.com.au
File: F-13409
Page 26 of 28
28/03/2017
92.
Align the FPS to the vehicle, ensuring the
following:
•
Lower faces of the wing and body cover
panel are flush
•
A 15-20mm gap is present at the bumper
cut location
•
There is a 15mm gap to the vertical face of
the vehicle body
•
The FPS is level across the width of the car
93.
Use the indicated hole in the sliding washer
plate as a guide and drill an Ø8mm hole
through the mounts in both sides of the
vehicle. Keep the drill square to align with
holes in winch frame.
94.
De-burr all new edges, clean any swarf from
the areas and apply rust preventative to
exposed surfaces.
95.
Secure through the holes drilled in step 93
using M8 x 1.25 x 35mm hex screws (2),
5/16” x Ø1
-
1/4” Flat Washer
s (4) & M8 x 1.25
nyloc nuts (2).
96.
Tension the fasteners to the specified torque
settings listed on page 1.
97.
Connect all wiring harnesses.
98.
Insert M6 cage nuts (3) into each wing guard
as shown opposite.
RHS SHOWN
LOWER FACES FLUSH
1
1
5
5
-
-
2
2
0
0
m
m
m
m
15mm
RHS SHOWN
RHS SHOWN
