FITTING INSTRUCTIONS
Product:
T13 Outback Deluxe Frontal Protection System
Vehicle:
Holden Colorado 2016+
Part No.
070SB13L32R
For product warranty, please refer to our website, www.tjm.com.au
File: F-13409
Page 4 of 28
28/03/2017
1.1.
Mark a point at the apex of the the
bumper countour.
1.2.
Draw a straight line from the point
marked in step 1.1 into the lower corner
of the spar, as shown.
1.3.
Mark a bumper trim line 15mm down
from the previously marked line, as
shown.
Repeat on opposite side of vehicle.
1.4.
Fit the supplied bumper cut template to
the bumper and mark the appropriate
trim lines.
2.
Remove (& retain) the number-plate,
discarding the fasteners.
3.
Remove (& retain) the screws (8) that are
securing the top of the grille/radiator shroud.
RHS SHOWN
RHS SHOWN
STEP 1.1
STEP 1.2
STEP 1.3
15mm
RHS SHOWN
