FITTING INSTRUCTIONS
Product:
T13 Outback Deluxe Frontal Protection System
Vehicle:
Holden Colorado 2016+
Part No.
070SB13L32R
For product warranty, please refer to our website, www.tjm.com.au
File: F-13409
Page 11 of 28
28/03/2017
33.
Mark the airdam for trimming using the
following process:
33.1.
Mark a point 200mm out horizontally
from the underside of the airdram
outrigger.
33.2.
Mark a point 25mm out horizontally from
the topside of the body member.
33.3.
Draw a straight line between the two
points.
33.4.
Draw a line horizontally across the short
face of the airdam, joining with the line
marked in step 33.3.
33.5.
Draw a line 90mm out from and parallel
with the back edge of the airdam, as
shown.
33.6.
Join the ends of the lines marked in
steps 33.4 and 33.5 with a straight line.
33.7.
Measure and mark a line 55mm out from
the indicated point on the airdam so that
it is inline with the indicated edge.
33.8.
Draw a line perpendicular to the one
marked in step 33.7 back towards the
vehicle body.
33.9.
Mark a line from the end of the one
drawn in step 33.8, along the
intersection of the lower airdam faces.
33.10.
Draw a line joining the ends of those
LHS SHOWN
200mm
25mm
LHS SHOWN
90mm
STEP 33.1
STEP 33.2
STEP 33.3
STEP 33.4
RHS SHOWN
55mm
POINT
EDGE
STEP 33.9
STEP 33.8
STEP 33.10
STEP33.7
