FITTING INSTRUCTIONS
Product:
Torq Winch 9,500lb Steel / 9,500lb Synthetic /
12,000lb Synthetic
Vehicle:
Generic
Part No.
947TJMTQ95SAA / 947TJMTQ95DAA / 947TQBK95DAA / 947TJMTQ12DAA / 947TQBK12DAA
For product warranty please refer to our website www.tjm.com.au
File: F-5969
Page 10 of 18
01/03/2021
ELECTRICAL CONNECTION
For self-recovery work, the fitment of a TJM Dual Battery System is recommended. A fully charged battery
and proper connections are essential. Run the vehicle engine during winching operations to keep batteries (2)
charged.
Important
When securing the leads to the terminals on the winch motor, ensure that two open end spanners are used to
secure the lead to the terminal (as shown).
Failure to do so will result in the internal connections of the
motor shorting out and void any warranty.
Pay close attention to proper electrical lead connection as follows (refer to Diagram 1)
•
Long black lead
– connects to negative (-) terminal of battery & to bottom terminal of motor (A).
•
Earth Lead (Thin black lead)
– connects to bottom terminal of motor (A).
•
Long red lead
– connects to positive (+) terminal of battery.
•
Short red lead
– to red stud (B) of motor.
•
Short yellow lead
– connects to yellow stud (D) of motor.
•
Short green lead
– connects to green terminal stud (C) of motor.
Diagram 8
A
B
C
D
