FITTING YOUR TJM TENT TO YOUR VEHICLE
Tent Orientation
Before you fit your new TJM tent to your vehicle, you will need to decide whether you wish to have the roof
top tent open over the back or to the side of your vehicle. To assist you with your decision, we have listed the
key features of each option below.
a. Opening over the back
Best suited for most larger sized vehicles
Leaves extra roof space for additional storage
Not recommended for vertical lift-gates
b. Opening off the side
Best suited for most small to medium vehicles
Allows for lift-gates to operate normally
The packed tent provides better balance on the roof and creates less wind drag
Once you have decided which is best suited to your situation, follow the relevant mounting instructions
illustrated in this manual.
If you are still uncertain as to the most appropriate method of mounting your TJM tent, please contact us and
we will be happy to provide advice particular to your circumstances.
Mounting Instructions – For tent opening over the back of vehicle
1. Remove the mounting extrusion from the carton and cut as per
Figure 1.
2. Place the tent on its side onto a clean surface on the ground
3. Using the four supplied 6mm bolts and 6mm fender washers, slide your hand in between the inside of
the case and mattress and insert the bolts into the pre-drilled holes.
Refer to
Figure 2.
4. Place the mounting extrusion into position over the bolts.
5. Slide the 6mm nuts into the mounting extrusions and tighten the bolts firmly from inside
the tent.
6. Mount the ladder to the base of the tent through the pre-drilled holes. Refer to
Figure 3.
Mounting Instructions – For tent opening off the side of vehicle
1. Place the tent on its side onto a clean surface on the ground
2. Using the four supplied 6mm bolts and 6mm fender washers, slide your hand in between the inside of
the case and mattress and insert the bolts into the pre-drilled holes. Refer to
Figure 2.
3. Place the mounting extrusion into position over the bolts.
4. Slide the 6mm nuts into the mounting extrusions and tighten the bolts firmly from inside
the tent.
5. Mount the ladder to the base of the tent through the pre-drilled holes.
Refer to
Figure 3.
cut here
Figure 1.
Figure 3.
6mm stainless steel bolt
fender washer
tent base
6mm nut
aluminium extrusion
slide plate with 8mm stainless
steel bolt
roof rack or roof bars
Figure 2.
2
TJM Roof Top Tents
Summary of Contents for Roof Top Tents
Page 1: ...Roof Top Tents Boulia 620RCTRT01 Yulara 620RCTRT02...
Page 2: ......
Page 8: ...www tjm com au...
