40
Setup
1
.
Remove first the cover of TK-MP3 phonecoach. Move the cover backwards
and in addition release it out of the holders on the back.
2.
Take the power cord out of the TK-MP3 phonecoach cover.
3.
Connect the mains unit (230V) with the power cord and then with the
TK-MP3 phonecoach.
After power on, the model and SW version
“TK-MP3 V1.xxDE“
will be
displayed. After 3 seconds, content of the display will switch to
„INFO & SERVICE TK-TRAINER.EU“
. After 5 seconds,
the basic
set up of TK-MP3 phonecoach is completed and ready for automatic record.
Package content includes a power cord extension. If the mains unit is out of
reach, you can extend the power cord by additional 2m.
4.
Take now both Gigaset handset phones out of the TK-MP3
phonecoach cover. Hold the red key pressed to switch on the
handsets.
To charge the battery pack of the phones, leave the handsets in the
base station for approx. 10 hours. Do not disconnect TK-MP3
phonecoach from the mains unit (230V) during charging.
Before first use, make sure that the 2 Gigaset handset phones are
enough and fully charged. Take care that before every training, the
2 Gigaset handset phones are enough and fully charged.
5.
The TK-MP3 is now ready for your training.
Only for phonecoach TK-MP3 with Bluetooth:
The GSM cell phone which appertain to package content, is already
registered to the TK-MP3 phonecoach and will be automatically
detected after power on.
Before first use, make sure that the GSM cell phone is enough and
fully charged. Take care that before every training the GSM cell phone
is charged.
6.
Take now the GSM cell phone out of the cover and insert a unlocked SIM-card
(appertains not to package content) according to user manual of the GSM cell
phone manufacturer.
7.
Switch on the GSM cell phone and enter your PIN-Code
.
NOTICE
NOTICE
NOTICE
IMPORTANT
IMPORTANT
Summary of Contents for PHONECOACH TK-MP3
