10
7. STARTING ENGINE/AIR
GAS ENGINE
1. With the Plate Compactor engine level in the ground check oil level and add oil
and fuel as required.
2. Pull the stop switch on the unit to its "Out" position.
3. Move the engine throttle control to the "FAST" position.
4. Choke the engine if necessary. (You may not need to choke a warm engine)
BEFORE STARTING ENGINE MAKE SURE ALL GUARDS ARE IN PLACE.
5. Pull the starter string.
6. After the engine starts, move the choke lever to the open position, move the
throttle level to the "IDLE" position and let the engine warm-up for one or two
minutes.
To stop the engine, make sure to let the engine idle before stopping by using
the crank lift handle to raise the grinder cutters height.
7. Push in the engine stop switch on the equipment.
8. Close the fuel valve.
ELECTRIC MOTOR
1. With the cage in maximum raised position, plug the motor into a suitable power
source.
2. Move the switch on the motor to the "ON" position.
STOP THE ENGINE OR ELECTRIC MOTOR BEFORE:
Adding fuel.
Leaving equipment unattended for any amount of time.
Making any repairs or adjustments to the unit.
Lifting/Transportation.
Discount-Equipment.com
