11
www.tkequip.com
(956) 796 - 9411
4.
Remove soil and clean the bottom of shoe.
5.
For wheel kit, Grease wheels (4) weekly
. Use high quality gun grease, Kendall “SHP High
temp” or equal.
6.
Clean air filter and foam pre-cleaner daily. More often if dry cutting. Always use foam
element pre-cleaner over paper cartridge. Never run engine with clogged or missing air
filter.
7.
FUEL PIPING AND CONNECTIONS SHOULD BE REPLACED EVERY 2 YEARS.
8.
Follow the maintenance schedule:
Maintenance
Each
use
Every
20 hours
Every
50 hours
Every
100 hours
Yearly
Engine
Refer to engine operator/owner
manual
X
X
Air Cleaner
Refer to engine operator/owner
manual
X
X
Spark Plug
Clean spark plug, and adjust the spark
gap to 0.024~0.028 inch (0.6~0.7 mm).
X
Engine Oil
Oil change & Leakage
X
Hardware
Check and tighten check torque diag.
X
X
X
in-line fuel
filter
Inspect in-line fuel filter and replace if
necessary.
X
Crank oil
Remove the oil drain plug on foot
housing and drain the oil. Refill with
approx. 0.8 qt. (0.75 liter) of 10W-30
SE, SF or higher-grade motor oil.
X
Wheels
Grease wheels and check wear
X
X
Damage
Broken parts or Damage
X
Fuel Tank
Clean the inside of the fuel tank with
solvent and clean fuel strainer replace
strainer if necessary.
X
11. REPLACEMENT
Parts
Tolerance or Replacement Cycle
Engine Components
✓
Refer to your engine manufacturer´s Owner´s Manual
Pistons
✓
Replace if machine is losing its power BPM.
✓
Grease/lubricated Centrifugal clutch yearly.
Rubber Stoppers
✓
Inspect the rubber anti vibration mounts for wear or
deterioration.
Hardware
✓
Re-torque all bolts after the first eight hours of
operation and check hardware every 25 hours. Replace
any worn or damaged hardware as needed.
Replacement hardware should be grade 5 and zinc.
Safety Decals
✓
Replace if they become aged, damaged or cannot be
easily read.
