TLA TUNING SET CTS-7-C, Manual

18

Press “E”. The device calculates the piano stretching and stores 
them. To start with the real work of piano tuning, search the function 
"tune" with the "note" buttons. Then it goes on, as described in Sec-
tion 3.5 of the manual for CTS-7. 

Note: Within the “PIANYZER”- procedure, you can back step using the “Note” buttons. 

3.10.2  How to produce a stretching by entering of support values (Piano Editor) 

The tones with the cent's for calculating the stretching, the sake of simplicity, will be referred 
to as "support note". Using the piano editor, the cents of the support-notes, you can enter by 
hand, rather than be determined by the analyzer (see sample diagram at the end of the 
chapter). 

Note: The piano editor allows you to edit the cents of the supporting notes, which were 
previously generated by the piano analyzer. 

To work with the Editor, do the following: 

After switching on the unit, look for an unused instrument pro-
gram i.e. „INSTRUMENT____10“. There you search the option 
"PIANYZER" using the "note" keys“ 

After pressing the key “E”, keep the die „S“ button pressed while 
at the same time tapping “F” button, to skip the write protection. 

Select the option „EDITOR“ using the “func” keys and press „E“ 
again. 

Select the highest tone of your piano which has a 2 string 
chorus and press “E”. 

Select the highest tone of your piano which has a 1 string 
chorus and press “E”. 

Play the note "a-1" to measure the concert pitch of your 
instrument and use the "Func" buttons to align the tuner. (See 
also capter 2.6 of the manual) or you already can tune the 
chorus of "a-1" to your desired pitch.  

By pressing the "E " you are starting to enter the cents of the 
“support notes. 

Using the „Func“ keys, you enter the Cents of the „support-note“ 
which is predefined by the tuner. With the  „E“or „< Note“ key 
you may switch to the next „support-note“. With „Note >“  key 
you can back step. 

If you have entered the cents for all the "support-notes" , you will 
get i.e. the following indicator. 

Press  “E”. The device calculates the piano stretching and stores 
them. To start with the real work of piano tuning, search the func-
tion "tune" with the "note" buttons. Then it goes on, as described in 
Section 3.5 of the manual for CTS-7. 

3.10.3  Diagram of an PIANYZER stretching 

… see next page. 

TUNE       ->110

INSTRUMENT

10

_a_2   3.0

E10

SUPPORT-NOTE   6

-26 -16  -8  -2

 0   3  11  36

TUNE       ->110

INSTRUMENT

10

PIANYZER   ->110

INSTRUMENT____10

SELECT       A10

EDITOR     <>

TUNE       ->110

INSTRUMENT____10

_d__   <>    S10

2-STRING CHOIR

_G#_   <>    S10

1-STRING CHOIR

_a_1         K10

440.00