12
Final Checkout Procedure of Assembled Lift
Confirm that all hydraulic and air lines are tight with no leaks
Check hydraulic oil level in reservoir and confirm hydraulic system has been bled of all air
Confirm that all electrical components have been wired properly and are operational
Confirm lift base and runways are level and all anchor bolts torque to 75 ft.-lbs. (102Nm)
Confirm safety locks are functioning properly
Lubricate all lubrication points
OPERATING and MAINTENANCE INSTRUCTIONS
LIFT OPERATION:
Before lifting a vehicle, insure all operators are qualified, have
been trained and are following all safety instructions. Read and follow the ALI
"Lifting It Right" manual
included with the lift
.
(see example of SAE J2184 standard below)
Insure that every vehicle will be securely
positioned on the lift (use wheel chocks).
When using air/hydraulic rolling jacks to lift
a vehicle, always use vehicle manufacturer's
recommended lifting points
(
CD included with the lift)
.
Insure all materials stay up to date » »
www.autolift.org/
Never allow anyone under the lift when raising or
lowering. Always insure mechanical safety locks
are completely engaged on both sides of the lift
before proceeding under the lift or a vehicle.
Lift operating controls are located on the console or hand held pendant
(
one "up"
button for raising the lift - one "level" button for lowering the lift into the safety locks for alignment -
and one "down" button for lowering the lift)
. Note: When pressing the "down" button, the
lift will first raise slightly to clear the safety locks and then proceed to lower.
LIFT MAINTENANCE :
Before maintaining, servicing or repairing the lift, insure that an
acceptable "lock out/tag out device is activated.
The following minimum maintenance schedule must be performed by the owner and/or lift
operator:
DAILY: - Raise and lower the lift
(with no vehicle)
at the beginning of each shift to verify the
runways are level and that the lift is operating properly.
- Check all hydraulic fittings and lines for damage and leaks. Check electrical wiring
for damage. Check all moving parts for uneven or excessive wear. Repair or replace
all damaged, worn, or broken components immediately.
- Clean all debris from the base frame area
- Remove oil/grease on runways and rolling jack lift pads.
lift maintenance continued on page 13 ……
