TM Electron Pro Series, Instruction Manual

15

ENGLISH

Coffee powders enter 

into the jug.

Brewing coffee takes 

longer than usual.

The coffee maker 

switches off before the 

water tank is empty. 

The coffee is not 

strong enough.

The coffee is too 

strong. 

The coffee does not 

taste good.

The coffee is not hot 

enough. 

The jug is difficult to 

place in the appliance 

or remove from the 

appliance.

There is less coffee in 

the jug than expected.

- Check if the grind & brew basket has overflowed because 

there is too much ground coffee in the grind & brew basket, 

or the jug has not been placed correctly under the grind 

& brew basket, or you remove the jug for more than 30 

seconds during brewing.

- Check if the filter is torn, or has not been placed correctly.

- The appliance needs to be descaled (see chapter ‘Desca-

ling’).

- The appliance needs to be descaled (see chapter ‘Desca-

ling’).

- Check if used coffee beans or ground coffee is not enough. 

It should be one heaped measuring spoon of coffee beans 

or ground coffee for each cup.

- Check if you use coffee beans or ground coffee with mild 

flavour.

- Check if used too much coffee beans or ground coffee. It 

should be one heaped measuring spoon of coffee beans or 

ground coffee for each cup.

- Check if you have used coffee beans or ground coffee with 

strong flavour.

- Check if you leave the jug with coffee on the warm plate too 

long, especially if it only contains a small amount of coffee.

- Check if the brewed coffee is too little. The coffee will  

warm longer if you brew more.

- Make sure you place the jug properly on the warm plate.

- Make sure the lid of the jug & filter basket are in right 

position.

- Tilt the jug a little of angle to place or remove it. Be careful 

not to spill the hot coffee for avoiding scald. 

- Check if you have no place the jug properly on the warm 

plate, so as to the anti-drip valve prevents the coffee from 

flowing out of the filter.

- The appliance needs to be descaled (see chapter 

 ‘Descaling’).