ENGLISH
15
Check that the plug is properly inserted
into the outlet or try plugging the stea-
mer into a different outlet.
Press the steam trigger or press the
power button to activate the steamer.
Always allow steamer to preheat at
least 35 seconds,or until the power
button light is a steady blue.
Follow the instructions under the “filling
the water tank” section and fill to MAX
level marker.
After preheating,always prime the wa-
ter pump by holding the steam trigger
until steam forms to ensure enough
water is in the boiler.
Empty the water tank after each use.
Only use distilled, filtered,or purified
water.
Regularly clean steamer and refrain
from using perfumed or scented
additives.
Allow the steamer to heat for about35
seconds.
Follow the instructions under the “Filling
the Water Tank” section and fill to Max
level marker.
The steamer is
plugged in but not
heating.
Not enough steam
or no steam is
coming out of the
steamer.
Discolored water is
coming through the
holes and staining
the fabric.
Steamer is leaking
or spitting.
There’s a power
supply issue.
The auto shut-off
has activated.
The steamer isn’t
heated up to full
temperature.
There is not enough
water in the water
tank.
The water pump
hasn’t been primed.
Residue has built
up in the water tank
or on the plate.
Perfumed or scen-
ted additives were
used.
Steamer is not hot
enough.
Water tank is run-
ning low.
Problem
Possible Cause
Solution
Summary of Contents for TMPPL020
Page 1: ......
Page 2: ......
Page 3: ......
Page 28: ...WWW TMELECTRON COM info tmelectron com Telf 34 918 719 276 Fax 34 918 719 354...
