Installation & Operation Manual
3.5.5 Date Offset
This field is used to select a forward offset, in days, to the current date. If the “Date Offset” value is selected as 0, the
current date will be displayed.
3.6 Count Up Timer
This section describes utilizing the up counting timer feature of the clock.
3.6.1 Use Count Up Timer
Check this box to use the count up timer. If unchecked, the fields in this section will be grayed out and inaccessible. As
soon as this box is checked, the clock will switch to the up-counter mode showing the reset value of “00:00:00”.
3.6.2 Display Mode
This field is used to select the format in which the up counter is to be displayed. The two options are “MIN:SEC:tSEC” and
“HR:MIN:SEC”. These will show minutes, seconds and tenths of seconds or it will show hours, minutes and seconds
respectively.
3.6.3 Start/Pause/Reset Buttons
The Start button for this section will begin an up counting timer. As soon as it's clicked, the button will dynamically switch
to read “Pause” so that it now acts as a pause button for the running timer. Clicking this Pause button will switch it back to
read “Start”, and it will immediately stop the timer to display its current values. Selecting this button again will continue the
up counting timer from this paused state.
The Reset button is only selectable when the timer is paused. It will clear the current timer values back to “00:00:00” so
that it can be restarted from this point. The up counting timer is also automatically reset whenever it leaves timer mode
and goes back to a normal clock display.
3.7 Count Down Timer
This section describes utilizing the down counting timer feature of the clock.
3.7.1 Use Count Down Timer
Check this box to use the count down timer. If unchecked, the fields in this section will be grayed out and inaccessible. As
soon as this box is checked, the clock will switch to the down-counter mode showing the reset value of the current
“Countdown Start Time” parameters.
3.7.2 Display Mode
This field is used to select the format in which the up counter is to be displayed. The two options are “MIN:SEC:tSEC” and
“HR:MIN:SEC”. These will show minutes, seconds and tenths of seconds or it will show hours, minutes and seconds
respectively.
3.7.3 Hours
This field is used to select an hours start time for the count down timer. This will not be selectable when the countdown
timer is in MIN:SEC:tSEC mode. Selectable from 0 – 23.
3.7.4 Minutes
This field is used to select a minutes start time for the count down timer. Selectable from 0 – 59.
3.7.5 Seconds
This field is used to select a seconds start time for the count down timer. Selectable from 0 – 59.
[ 8 ]
TimeMachines Inc. | 300 South 68th St. Place, Suite 100 | Lincoln NE 68510
voice: 402.486.0511 | email: tmsales@timemachinescorp.com | web: timemachinescorp.com
