7
SETTING THE CURRENT TIME
1. Press button C (Time/
u
) to enter current time. The clock will flash whilst in the settings
mode.
2. Press button C (Time/
u
) again to scroll through the hours and minutes (selected item will
flash) and using button D (Manual Feed/+) increase the hours/minutes to the correct time.
3. Press button A (Pump/OK) to confirm and save the current time.
SETTING DOSING VOLUME
1. Press button A (Pump/OK) a number of times to scroll through all pump numbers until you
find the pump you wish to set dosing details for.
2. Press button B (Dose/
t
) to enter the dosing volume setting.
3. Press button D (Manual Feed/+) to adjust the first two digits (from 1 - 19) of the dosing
volume and then press button C (Time/
u
) to move onto the third digit of the dosing
volume and adjust using button D (Manual Feed/+) (1 - 9). For example, if you wanted to set
the dosing volume to 149ml, you would set the first two digits to 14 and the third digit to 9.
Please Note:
Dosing volume can be set from 1ml to 199ml per dose.
SETTING DOSING TIMES
After setting your dosing volume you can set
when
to dose. Each pump can deliver your
determined dosing volume up to 24 times per day, on each hour, should you require it. Each
pump will start approximately 3 minutes after the previous one in order to allow time for
your chosen additives to mix with your aquarium water. For example if you set two pumps to
dose at 10am, the first will dose at 10am and the second will dose at approximately 10.03am.
1. After setting your dosing volume press button C (Time/
u
) to scroll through to the ‘when
to dose’ section of the screen. 1 to 24 represents each hour of the day in 24hr time
format. Press button C (Time/
u
) to scroll right, or button B (Dose/
t
) to scroll left. An
hour time slot will flash then you are able to select/deselect it.
2. Use button D (Manual Feed/+) to select/deselect the hours when you would like the
pumps to dose. The selected hours will be underlined when the button is pressed and will
be deselected by pressing button D (Manual Feed/+) again. No line will show under the
number when it is deselected.
3. Repeat the above process for all dosing pumps and then press and hold down button A
(Pump/OK) for 2 seconds to confirm and save the settings for all pumps. The dosing unit
will now be in running mode and the ‘:’ on the clock will now be flashing.
