3
INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
- Always isolate from the mains electricity before installing or carrying out any
maintenance to the top up system.
- Power to the top up system must be supplied through a Residual Current Device (RCD)
with a rated residual operating current not exceeding 30mA.
- To ensure the top up system functions correctly, the float switch(es) and the pump must be
cleaned regularly to ensure they do not become clogged with debris or detritus.
- The float switch(es) must always be installed in an upright position with the power cable
pointing upwards. Failure to do so will result in operating problems and water overflowing
from your sump or aquarium.
- Pump rating: 220-240V, 50Hz unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it
has been dropped or damaged in any way.
- This unit is designed to be used indoors and is not suitable for any outdoor applications.
- Ensure the V
2
Auto Top Up System is safely positioned before operating.
- Always leave a drip-loop in the cables to prevent water running down the cable and
reaching the power source (see below).
- Dispose of this unit responsibly. Check with your local authority for disposal
information.
s
Drip Loop
