GENERAL INSTALLATION
The V
2
Auto Top Up System is designed for simple installation internally in the aquarium or
sump.
1. Ensure there is adequate space in the aquarium or sump to allow the float switch and
mounting bracket to be correctly installed.
Please Note:
The float switch must always be installed in a vertical, upright position with
the power connection cable at the top (see photo 5). Failure to do so will result in
operating problems and water overflowing from your sump or aquarium.
2. Install the float switch at the desired water depth in your preferred location in your
aquarium or sump, ensuring that it is in a position where it will not be subject to excessive
air bubbles or vigorous water movement.
Please Note:
The float switch must be installed so the flexible top up hosing securing
clamp and top up hosing are positioned above the aquarium or sump water level AT ALL
TIMES. Failure to do so will cause water to back-siphon when the pump switches off and
result in water overflowing from your sump or freshwater container.
Please Note:
If you are using the V
2
Auto Top Up
Plus
System, which incorporates two
float switches, both must be positioned in the aquarium or sump to ensure that the correct
trigger signal will be sent when required (see photo 6).
5
5
6
