Operating Instructions
Quick start
1. Ensure the clear plastic battery protection tab is removed from the bottom of the remote control
(see page 4).
2. To use the remote control, point it at the infrared sensor at the cable entry to the light unit.
3. Press to set the clock. Press once to adjust the hour and twice to adjust the minute.
Use and to adjust up or down.
The time setting will be automatically saved after ten seconds, or you can press to go back to
your user set program with the updated time.
4. Press to choose between 24 hour and 12 hour clock format.
5. Press to run the set program (details of the factory set program on page 8).
6. Press to switch the light off.
7. Press to enter storm mode. Use and to change the frequency of lightning strikes.
Press to return to the set program.
8. Press to enter a colour demo. Use and to change the speed of the transitions.
In the slowest settings this can be used to simulate clouds passing over. Press to return to the
set program.
9. Press repeatedly to cycle the display through, showing the temperature of the light unit in °C
and °F and the electrical power being drawn by the light unit in Watts.
10. Press to slave the unit from another controller (sold separately).
RUN
RUN
OFF
RUN
COLOUR
DEMO
O
C/
O
F/
W
SLAVE
RUN
24/12
6
V2iLumenAir 900-1200 instructions multilingual v2-2014 REWORKED FINAL_Layout 1 25/07/2014 12:28 Page 8
