Step 3: Connect Power Cord
1 Connect Power Cord to Module
2 Connect Power Cord to Wall Outlet
1 Connect Audio Cable to Module
2 Connect Audio Cable to Music
Source
Step 4: Connect Music Source
Installing Your Music on Hold Adapter
Step 1: Connect Line Cords
Connect one end of a long telephone
line cord to the jack on the back of the
feature module labeled L1/L2. Connect
the other end to the jack(s) labeled Lines
1 & 2.
NOTE: If you wish to plug in the mod-
ule to a jack that is already in use,
unplug the existing device from the
wall jacks, connect both of the line
cords to the module as shown, and
then plug the device into the jacks on
the module labeled “TO PHONE.”
IMPORTANT: Make
sure that switch 7 is
set in the up position
and swich8 is set in
the up position.
Reference Drawing
Jacks for connection
to Wall
Jacks for connection
to a Phone
Dip Swithces
Music Volume Control Knob
for Music on Hold Adapter
Paging Volume Control Knob
for External Paging Adapter
Ac Adapter Jack
Strain Relief Tab
Status Indicator Lamp
Plug the AC power cord into the adapter
jack at the rear of the Feature Module.
Thread the power cord around the strain
relief tab.
Plug the AC adapter into an electrical
outlet
not controlled by a wall switch.
Make Sure that Status Indicator lamp
is Blinking
This indicates that the feature module is
properly connected to electrical power.
The blinking pattern for the Music on
Hold Adapter is a continuous rapid on
and off blinking.
Plug one end of the supplied audio
cable (with 1/8” plugs at each end) into
the Music Input Jack on the rear of the
feature module.
Plug the other end of the audio cable
into the music output jack of your music
source. Most radio and tape players are
equipped with jacks for 1/8” plugs.
However, if your music source has a dif-
ferent type of jack, various type of con-
nectors are sold many places, for exam-
ple Radio Shack.
1 Connect First Line Cord
2 Connect Second Line Cord
Set Switches 7-8
Step 2: Set DIP Switches to Proper Positions
Set switch 7 in the up position and switch
8 in the up position to set this feature
module as a Music on Hold Adapter.
Connect one end of a long telephone line
cord to the jack on the back of the fea-
ture module labeled L3/L4. Connect the
other end to the jack(s) labeled Lines 3 &
4 in the same manner as described in
the previous step.
Lines
1&2
Lines
3&4
L1/L2 L3/L4
Music Input Jack
for Music on Hold Adapter
