WARNING!
To avoid personal injury and/or property damage,
permit only trained personnel to operate lift. After
reviewing these instructions, get familiar with lift
controls by running the lift through a few cycles before
loading vehicle on lift. Always lift the vehicle using all
four adapters. NEVER raise just one end, one corner,
or one side of vehicle.
W W W . T M G I N D U S T R I A L . C O M
P 1 7 / 2 8
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
TO RAISE THE LIFT
1.
Before Loading: Lift must be fully lowered and
service bay cleared of all personnel before the vehicle is
brought on lift with the arms (if used) set to the full drive-
thru position.
2.
Loading: Position arms under vehicle and position
adapters at vehicle manufacturer’s recommended lift
points. Use height extenders or optional frame-cradle
adapters (if applicable) when necessary to ensure good
contact. (See Fig 10.1)
Fig. 10.1
WARNING!
Many specialty or modified vehicles cannot be
raised on a two-post frame engaging lift. Contact
vehicle manufacturer for raising or jacking details.
TYPICAL LIFTING POINTS
3.
Some vehicles may have the manufacturer's Service
Garage Lift Point locations identified by triangle shape
marks on the undercarriage (reference ANSI/SAE J2184-
1992). Also, there may be a label located on the right
front door jamb area showing specific vehicle lift points.
4.
Position vehicle for proper weight distribution arms
un- der vehicle to allow adapters /pads to contact at the
manu- facturer’s recommended pick up points.
