W W W . T M G I N D U S T R I A L . C O M
P 0 9 / 4 1
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
Wiring Instructions
Disconnect, tag and lock out
power source before
attempting to install, service, relocate or perform any
maintenance.
1. Check the voltage, phase and proper amperage
requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
Overheating, short circuits and fire damage will result from
inadequate wiring. Wiring must be installed in accordance
with National Electric Code and local codes and standards
covering electrical apparatus and wiring.
Be certain that adequate wire sizes are used, and that:
Service is of adequate amp rating.
The supply line has the same electrical characteristics
(voltage, cycles and phase) as the motor.
The line wire is the proper size and that no other
equipment is operated from the same line.
Motor Rotation Check
Once the machine is hooked-up, turn the machine on using
the on/off switch.
Ensure that the rotation direction of the pump is the
same as indicated by the arrow on the motor cover. If not,
contact the Customer Service. Wiring should be
performed by a certified electrician only.
Anchoring
It is not essential to anchor the machine to the floor,
however, the floor must be smooth and level and permit
the platform rollers to move freely. When anchoring to a
concrete floor use the mounting holes that are provided in
the frame. Make sure the machine is solid and level and
supported evenly on all anchor points. Solid shims may be
used if necessary.
