W W W . T M G I N D U S T R I A L . C O M
P 0 3 / 4 1
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
DEFINITIONS OF
HAZARD LEVELS
Identify the hazard levels used in this manual with the
following definitions and signal words:
Watch for this symbol: It Means: Immediate hazards which
will result in severe personal injury or death.
Watch for this symbol: It Means: Hazards or unsafe
practices which could result in severe personal injury or
death.
Watch for this symbol: It Means: Hazards or unsafe
practices which may result in minor personal injury or
product or property damage.
Watch for this symbol! It means BE ALERT! Your safety,
or the safety of others, is involved!
OWNER’S RESPONSIBILITY
To maintain machine and user safety, the responsibility of
the owner is to read and follow these instructions:
1. Follow all installation instructions.
2. Make sure installation conforms to all applicable Local,
State, and Federal Codes, Rules, and Regulations; such
as State and Federal OSHA Regulations and Electrical
Codes.
3. Carefully check the unit for correct initial function.
4. Read and follow the safety instructions. Keepthem
readily available for machine operators.
5. Make certain all operators are properly trained, know
how to safely and correctly operate the unit, and are
properly supervised.
6. It is the responsibility of the facility owner toproperly
designate work areas and areas where by-standers are
not permitted.
7. Allow unit operation only with all parts in placeand
operating safely.
8. Carefully inspect the unit on a regular basis and
perform all maintenance as required.
9. Service and maintain the unit only with authorized or
approved replacement parts.
10. Keep all instructions permanently with the unit andall
decal’s on the unit clean and visible.
Do not attempt to operate this equipment if you have never
been trained on basic truck tire service and mounting /
dismounting procedures.
ALWAYS STAY CLEAR OF MOVING PARTS
