・
The explanation here is only for the particular point of Cal.VD51B
1.REMARKS
ON
INSTALLING
THE
BATTERY
1)After the battery is replaced with a new one or after the
battery is reinstalled following the repairing procedures,
Be sure to touch the short-circuit the AC terminal of circuit
block and the switch spring with conductive tweezers
to reset the circuit as illustrated at right.
2) When the battery replaced with a new one, the time information stored in the built-in IC and
the time indicated by the stopwatch hands do not correspond with each other.
Reset the stopwatch hands to "0" position following the procedure below.
If the stopwatch hands should move improperly, also follow the same procedure.
①
Pull the crown out to the second click.
②
Keep buttons "A" and "B" pressed at the same time
for 2 seconds, and then, release the buttons.
The stopwatch second hand move back and returned
to where it was.
③
Press button "A" or "B" to reset the stopwatch second
and minute hands to"0" position.
* By pressing button "A" , set the stopwatch 1/1 second hand.
* By pressing button "B", set the stopwatch minute hand.
④
Turn the crown to set the hour, and minute hands to
the desired time, and push the crown back in to the
normal position.
6
SII Products
Version-02
Cal.VD51B
TECHNICAL GUIDE
