background image

Series 

Deskstar 7K1000.B 

Deskstar 7K1000.B 

Deskstar 7K1000.B 

Model Number 

HDT721025SLA380 

HDT721050SLA360 

HDT721010SLA360 

Capacity 

250 GB 

500 GB 

1 TB 

Series

Deskstar 7K1000.C

Deskstar 7K1000.C

Deskstar 7K1000.C

Model Number

HDS721025CLA382

HDS721050CLA362

HDS721010CLA332

Capacity

250 GB

500 GB

1 TB

Remove.

Remove.

DVD drive

DVD drive

C-DR091D
C-DR161D

HARD DISK DRIVE 
INSTALLATION PROCEDURE MANUAL

1. RECOMMENDED HARD DISK DRIVE

Made by Hitachi Global Storage Technologies

Note

Be sure to use the recommended hard disk drive. Failure to do so could cause a recognition failure or data
reading/writing errors.

2. HARD DISK DRIVE (HDD) INSTALLATION PROCEDURE

Notes

• Be careful when handling a HDD.
• The HDD is a very precise device and can be damaged by static electricity, shocks, and vibrations.

2.1. Settings

DIP switch setting and cable connection must be changed when installing only a single HDD. Detach the DVD
drive with the following procedures, then change the setting.

1. Remove 8 screws on the rear and both sides of the case, then detach the case. 

Replace the removed case after all work is complete.

2. Remove the screws, then detach the DVD drive.

Summary of Contents for C-DR091D PL

Page 1: ...ies Note Be sure to use the recommended hard disk drive Failure to do so could cause a recognition failure or data reading writing errors 2 HARD DISK DRIVE HDD INSTALLATION PROCEDURE Notes Be careful when handling a HDD The HDD is a very precise device and can be damaged by static electricity shocks and vibrations 2 1 Settings DIP switch setting and cable connection must be changed when installing...

Page 2: ...DVD drive Factory default setting DIP switch 3 Change the DIP switch setting as shown in the table below 5 Replace the DVD drive removed in Step 2 4 Change the cable connection as shown in the below DVD drive Remove CN2003 CN4 CN5 Change CN2004 Change Factory default setting Setting after change DVD drive connection signal CN2004 CN2003 power supply CN5 CN4 ...

Page 3: ... capacity In case of a single HDD HDD HDD HDD 2 2 HDD Installation 1 Remove the mounting brackets attached inside of the Digital Video Recorder DVR then attach them to the HDD Secure the HDD to the chassis 2 Connect both the signal cable and power supply cable to the HDD ...

Page 4: ...ard disk error occurs and the DVR cannot be used Note Do not disconnect the power supply plug while the power key is lighting Be sure to place the DVR in standby mode before removing the power supply plug 1 Connect the power supply plug to the AC wall outlet The DVR is placed in standby mode and the power key flashes at about 5 second intervals 2 Press the power key in standby mode The screen is d...

Reviews: