78
16.4. Making Communications without Performing Network Settings
(Simple Connection)
Note
This connection method is available only for the system consisting of only the units (10 units or less), PC, and
switching hubs that are connected to a closed network.
Any Unit ID should not be duplicated. (If duplicated, perform the Unit ID setting in the Connection Settings.)
If other network equipment is connected to this network, the equipment operation may be adversely affected.
If this requirement is not satisfied or when connecting 11 units or more, take the method to make
communications after performing network settings (see
) instead of this simple connection method.
Step 1.
Select [Remote
Simple Connection]
from the menu.
The Simple Connection screen is
displayed.
Step 2.
Read the displayed precautions, and press the [Yes] button after confirming that the requirements are
satisfied.
The units within a closed network
are being searched while the screen
at right is displayed
Notes
• If 11 units or more are detected, the message at
right is displayed. In such a case, set the number
of units to be connected to a closed network to 10
units or less.
• When the firmware is not compatible with this
software (firmware earlier than version 2.00), or
the Unit ID is duplicated, it is not possible to
perform simple connection.
Update the firmware or change the Unit ID in the
connection settings.
Summary of Contents for DP-K1
Page 102: ...200705 URL http www toa jp...
