7. CONNECTION
8. OPERATION
9. USING THE SWITCH SELECTOR MODE
Step 1. Set the amplifier's microphone volume control to the minimum position.
Step 2. Plug the phone jack of microphone unit to the amplifier’s microphone input.
Switch off the power, when not in used.
Selector switch have 2 modes. There are battery mode and phantom power mode. If using battery as power input, select
the switch to battery position and if using phantom power as power input, select to phantom power position.
URL: http://www.toa.com.sg
133040004100
6.2. Battery Insertion
6. BATTERY
6.1. Life Span
Assuming application and usage being 1 hour/day, unit can be
used for 6.7 months to 9.3 months depending on brand and
type of batteries.
Step 1. Open the battery cover. Insert the battery according to battery polarity
(see the right picture )
Step 2. Put back the battery cover to product
Step 1. Use the necklace hanger to the neck, adjust the flexible shaft to first position ( see the top right picture). Hook
the both the clips to clothes, shirt, etc on your body.
Press the microphone ON/OFF button. The LED on the unit will light blue, turning on the microphone.
Step 2. Keep your mouth 3 – 6 cm away from the microphone and speak normally for the best possible sound reproduc-
tion. Adjust the microphone orientation for the best position by turning its flexible shaft. If distance of mouth is
too near, it causes voice distortion. Adjust the microphone by pulling away or lowering it. This is due to the high
sensitivity of the microphone.
Step 3.
Note : The battery will be depleted if the microphone is not turn off after used.
10. SPECIFICATIONS
Polar Pattern
Cardioid
Rated Impedance
600 ohm, Balanced
Frequency Response Mic
60 Hz ~ 20 kHz
Output Connector
1/4 “ Balanced L Plug, 200 mm
Power Source
3V DC ( 2 x "AAA" batteries ) or Phantom power ( 9 ~ 52 V )
Cable Length
Flexible Shaft : Copper Alloy, Black, Paint, Shield tube
Battery Case Unit, Switch Unit, Mic Unit : ABS Resin, Black,
Weight
190 g ( exclude batteries )
7 m
Finish
0 °C to +40 °C (32 °F to 104 °F)
Wire Hanger : Steel wire shield rubber, Black, Paint
Dimensions
260 mm ( h ) x 135 mm ( w ) (10.24” x 5.31”)
Microphone Element
Electret Condenser
Rated Sensitivity
-35 ± 3 dB ( 1kHz 0 dB = 1 V/Pa )
Operating Temperature
Note: The design and specifications are subject to change without notice for improvement.
Distance Mic
to mouth
± 3 - 6 cm
