27
ON
OFF
ON
OFF
11.5. Confirming the Recorded Contents on Memory Card
Follow the procedures below to confirm the recorded contents on memory card before playing, recording, or
deleting them. Audio signals are not output from the Line outputs 1 and 2 but you can check the contents using
the headphones connected to the Headphone output jack.
Step 1. Select a phrase number or program number for each operation of playback, recording, and deletion.
For playback, select a program number.
(Refer to Step 2 on p. 20.)
For recording, select a phrase number.
(Refer to Step 3 on p. 22.)
For deletion, select a phrase number.
(Refer to Step 2 on p. 25.)
Step 2. Press the Monitor key.
The Monitor indicator lights, and monitor playback of the selected sound
source will start and the playback is output only to the headphones.
Tip
Monitor sound is not output from the Line output terminals 1 and 2.
Step 3. To stop monitoring partway through the playback, press the Monitor
key again.
The Monitor indicator goes off and monitor playback is terminated.
Tip
After playback of the selected audio source is complete, the Monitor
indicator goes off automatically and monitor playback will be terminated.
11.6. Disabling Each Key Operation on the Front Panel (Lock Mode)
After you finish all necessary front key operations, place the unit in Lock mode.
Key operation except the Menu key is disabled, preventing accidental wrong operation.*
* Note that when the Quick stop function is set to "Enabled," Stop operation by the Start/Stop key during
playback is enabled. (See p. 88, "QUICK STOP FUNCTION.")
11.6.1. Placing in Lock mode
To select Lock mode, press the Menu key several times or hold down the Menu key for
2 seconds or more.
The Lock mode indicator lights, then the unit is placed in Lock mode.
11.6.2. Cancelling Lock mode
Press the Menu key while in Lock mode (when the Lock mode indicator is lighting).
The Lock mode indicator goes off, and the Lock mode is cancelled.
