90
28.2. Operation of the Unit When the Backup Function Is Enabled
[When the Backup function is enabled]
• The Backup indicator lights.
• When rewriting data by the operation like recording or deletion with the Backup function enabled, both data
on the Memory cards A and B are rewritten at the same time.
Note
Even when the Backup function is enabled, it does not operate when the unit is placed in the state below. In
this case, the Backup indicator flashes. Be sure to use the Backup function while Backup indicator is lighting.
When the Backup function is enabled
Remedy
When data on the Memory cards A and B is not
identical
Make sure data on the Memory card A is duplicated
on the Memory card B.
When the unit is operating using the Memory card B
while the Backup function is activated
See p. 91.
When the Memory card A takes over the operation
during operation using the Memory card B
Restart the unit.
[When the backup function is activated if an error has occurred on the Memory card A]
• If data reading on the Memory card A fails when playback start is triggered, data is read immediately from the
Memory card B, allowing the playback to start. Operation is maintained thereafter using the Memory card B.
• If data reading on the Memory card A fails during playback, data is read immediately from the Memory card B,
allowing the playback to start from the beginning of the phrase that was being played. Operation is maintained
thereafter using the Memory card B.
• The Memory card B in-use indicator and the Backup indicator flash when the Memory card B takes over the
operation by the Backup function.
Note
Noise may be produced when switched to the operation by the Memory card B.
Memory card B in-use indicator
• Operation by the Memory card B is the same as that by the Memory card A.
• No playback is performed if data reading on the Memory card B fails when playback start is triggered during
operation using the Memory card B.
