5-15
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
Points to Check
The NX-100 or NX-100S unit may have
failed. Check to see if the power supply
is correctly connected, that there are no
irregularities in the network, and whether
or not the NX-100's or NX-100S' front
panel-mounted Error indicator is lit.
Settings may be incorrect. Check both
the Setup and Operation programs for
correct setting.
The unit may be simultaneously
activated from multiple units. Restart up
the unit after broadcasts from other units
have finished.
10. ERROR MESSAGES
If any of the following messages is displayed in the message display area, the NX-100/100S may be
malfunctioning or have failed.
Note
In the above messages, "OO" indicates a unit's name and IP address, and "XX" indicates the channel
number.
Message
• "OO" connection failure.
• Connection failure to all designated units.
• "OO" connection failure - Incomplete broadcast.
• No broadcast. - Connection failure to all units.
• Interrupted broadcast to "OO".
• Interrupted broadcast from "OO".
Note:
The above messages are displayed in red.
• "OO" connection failure. - Invalid system name.
• No start. - Invalid broadcast setting contents.
• "OO" contact output "XX" set to OFF.
• "OO" connection failure. - Maximum number of connectable
PCs exceeded.
• No start. - Designated unit busy.
• "OO" contact output "XX" already ON.
• "OO" contact output "XX" turned OFF by other contact or PC.
• "OO" contact output "XX" already OFF.
Summary of Contents for NX-100
