Chapter 6
APPENDIX
Symptom
Remedy
Outputs no audio signal or distorted
signal.
onfirm that sound source e uipment amplifier and spea er are
correctly connected.
onfirm that input volume control is properly ad usted.
onfirm that the rear mounted input level selection s itch
itches
7 and 8 of the DIP switch for equipment settings) is set to appropriate
position.
Check audio activation control input for correct setting.
See
p. 3-56, "CONTROL INPUT SETTINGS,"
for control input
activation.
Check to see if audio-related settings, such as sampling frequency
and compression, are correct.
See p. 3-35, "Broadcast Spec Settings,"
for audio-related
settings.
Audio output is affected by noise or
lost.
When hum noise is heard, unit's SIGNAL GND terminal may not be
correctly connected.
Check to see if it is correctly connected.
When short noises are heard or when audio output is lost, network
may be congested. Check log contents. If congestion is found,
consult with network management personnel.
ee p.
tream og
to confirm log contents.
udio outputs are mixed.
hen broadcasts are heard mixed in multicast streaming the
same multicast address may have been set for some broadcasts in
broadcast spec setting.
Avoid duplication of multicast address when performing settings
for system units.
Other malfunctions
When other malfunctions occur, error indicator may light.
Since serious failure may have occurred when error indicator
lights, check log.
See
p.
peration og
to confirm log
contents.
orgot pass ord.
Contact your TOA dealer.
Summary of Contents for NX-300
