Chapter 3
SYSTEM SETTINGS (NX-300 SETTING SOFTWARE)
3-21
5. Model
Displays the list of unit model names registered
in the system.
6. Name
Displays the list of unit names registered in the
system.
7. IP address
Displays the list of unit IP addresses registered in
the system.
8. Check all button
Selects all units shown in the unit list.
9. Uncheck all button
Deselects all units shown in the unit list.
10. Delete button
Deletes all units checked in the unit list.
11. Network tab
sed to set each unit s
address and port
number.
(See
p. 3-28.
)
12. Broadcast spec tab
sed to set broadcast uality.
(See
p. 3-35.
)
13. Pattern tab
sed to set each unit s broadcast and contact
bridge destinations.
The Control Pattern, Broadcast Pattern and
Contact Bridge Pattern buttons can be used to
switch between pattern setting screens.
(See
p. 3-38.
)
14. Control I/O tab
sed to set operations at the moment the unit s
control input
(see
p. 3-56
)
and control output
(see
p. 3-61
)
are activated.
15. Serial tab (NX-100 only)
sed to perform settings for transmission and
reception of serial data (RS-232C).
16. Audio file (NX-300 only)
Stores audio les in the unit s built-in memory.
Summary of Contents for NX-300
