INSTALLATION MANUAL
IP MODULE
SX-200IP
Thank you for purchasing TOA’s IP Module.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
• Before installation or use, be sure to carefully read all the instructions in this section for correct and safe
operation.
• Be sure to follow all the precautionary instructions in this section, which contain important warnings and/or
cautions regarding safety.
• After reading, keep this manual handy for future reference.
2. GENERAL DESCRIPTION
The SX-200IP, designed to be installed in the SX-2100AI Audio input unit of the SX-2000 series, is an Interface
module for connection to the N-8000 series.
By connecting the SX-200IP to a network (LAN or WAN), paging announcements can be made to the SX-2000
system using the N-8000 series’ station(s) (N-8600MS and N-8610RM) employing the packet audio technology.
Each function is set by the dedicated setting software on a PC.
3. FEATURES
• Up to 8 SX-200IPs can be used per SX-2000 System.
• Paging announcements can be made to up to 8 SX-2000 systems using the SX-200IPs.
4. SPECIFICATIONS
Network Section
Network I/F:
10BASE-T/100BASE-TX (Automatic-Negotiation)
Network protocol:
TCP/IP, UDP, HTTP, RTP, ARP, ICMP, IGMP
Connector:
RJ45 connector
for LAN
Voice sampling frequency: 16 kHz, 8 kHz (controllable on the software)
48 kHz sample rate is used for SX-2000 system only.
Quantifying bit number:
16 bits
Voice encoding method:
Sub-band ADPCM, Cryptosystem
Voice packet loss recovery: Silence insertion
Audio delay time:
80 ms, 320 ms (controllable on the software)
Indicator
Operation indicator (RUN)
Operating Temperature
0 to 40 ºC
Operating Humidity
90% RH or less (no condensation)
Finish
Panel: Pre-coated steel plate, black, 30% gloss
Dimensions
35 (w) x 119.5 (h) x 178.4 (d) mm
Weight
150 g
Note: The design and specifications are subject to change without notice for improvement.
Indicates a potentially hazardous situation which,
if mishandled, could result in death or serious
personal injury.
WARNING
• Do not expose the unit to rain or an environment
where it may be splashed by water or other liquids,
as doing so may result in fire or electric shock.
• Should the following irregularity be found during
use, immediately turn off the power supply to the
SX-2100AI Audio Input Unit where the SX-200IP
is installed and contact your nearest TOA dealer.
Make no further attempt to operate the unit in this
condition as this may cause fire or electric shock.
· If you detect smoke or a strange smell coming
from the unit
· If water or metallic object gets on the circuit board
· If the unit falls or breaks
· If it is malfunctioning (no tone sounds.)