10
1
5.2. TS-D1000-SU Sub Control Unit
[Front]
[Rear]
2
3
4
5
6
1. Power indicator (White)
Lights when power is switched ON.
This indicator interlocks with the Master control
unit’s power switch operation when the Master
control unit and the supplied AC adapter are
connected to the Sub control unit.
2. Signal ground terminal
When connection of an external device to the TS-
D1000-SU results in the generation of audible
noise, connect this terminal to the Signal ground
terminal of the external device. Noise output should
be greatly reduced.
Note
This is not a protective ground connection.
3. Cable clamp
Route the power cable through this clamp to
prevent the AC adapter plug from accidentally
being disconnected.
4. DC inlet
Insert the power plug from the unit’s supplied AC
adapter into this inlet.
5. Conference unit connection terminals
RJ45 × 3
Connect conference units to these terminals using
CAT5e STP LAN cables. Up to 16 Conference units
can be daisy chain connected to each terminal.
6. Sub-control unit connection terminals
RJ45 × 2
Connect the Master control unit or other Sub
control units to these terminals using CAT5e STP
LAN cables.
Tip
Either terminal may be used for connection.