DIAGRAM 2
DIAGRAM 3
3
Tips: If you are unsure of a garment’s fabric content, start on a low setting and
test the iron on an area of the garment that does not show, such as a seam.
Gradually increase the heat setting until wrinkles remove without damaging the
fabric.
To freshen up garments made of velvet, felt, suede or velour, hold the steam-
ing iron horizontally 2 inches above the fabric for a gentle steaming.Make sure
the iron does not come in contact with the fabric.
To prevent shine, iron dark garments or those made of silk, acetate or rayon
inside out.
USING AS A DRY IRON
The iron can be used on the dry setting with or without water in the tank, how-
ever it is best to avoid having the tank too full of water while dry ironing.
1. Position temperature control dial to MIN, lowest setting. Diagram 2.
2. Turn the variable steam dial to the lowest setting. Diagram 3.
3. Stand the iron on its heel in an upright position on an iron-safe surface and
plug it in.
4. Turn the temperature control dial to the desired setting. Diagram 2.
5. When the ready light turns off, the iron has reached the desired tempera-
ture.
6. When finished, turn temperature control dial to MIN, and unplug. Allow the
iron to cool before cleaning the exterior or storing.
NOTE: During ironing, the ready light may turn on again which indicates that
the iron is heating up to maintain the proper temperature.
CAUTION: If the iron has been used for a long time and is hot, DO NOT fill it
with water.
USING AS A STEAM IRON
When using as a steam iron, be sure the temperature setting on the control dial
is within the STEAM range to avoid water spotting on a garm e n t .
1. Position temperature control dial to MIN, lowest setting. Diagram 2.
2. Position the variable steam dial to lowest setting. Diagram 3.
3. With the unit UNPLUGGED, fill the iron with water. (See FILLING THE
WATER TANK instructions.)
4. Stand the iron on its heel in an upright position on an iron-safe surface and
plug in.
MINIMUM
MAXIMUM
