7
Parts checklist
Positioning the car seat
The child car seat
MUST ONLY
ever be used on a forward facing passenger seat
WITHOUT
an active airbag.
Whilst in group 1 mode, the child car seat can only be installed using the ISOFIX anchor points
WITH
the top
tether. It
MUST NOT
be installed with out the top tether whilst in group 1 mode.
Whilst in group 2 and 3 modes, the child car seat can be installed using either the ISOFIX anchor points or the
vehicle’s 3-point seatbelt.
WARNING! The top tether MUST NOT be used if installing the seat using only the 3-point seatbelt.
WARNING: Never attempt to use a 2-point seatbelt to secure the seat.
WARNING: Never use on a seat with an active airbag.
WARNING: Never use on rearward or side facing vehicle seats.
1. To check if you have ISOFIX points,
feel between the joint of the passenger seat
back and passenger seat base (A) for two
metal brackets similar to (B). If unsure
or in any doubt then consult your vehicle
manufacturer.
A
B
Position
ISOFIX*
Seat belt type
3-point 2-point
Front passenger seat (no active airbag)
Yes
Yes
NO
Front passenger seat (active airbag)
NO
NO
NO
Back left & right seats
Yes
Yes
NO
Back centre seat
Yes
Yes
NO
Side or rear facing seats
NO
NO
NO
*
If fitting the car seat using ISOFIX in group 1 mode, then your
vehicle MUST have top tether anchor points and you MUST use the
top tether system.
The top tether is not necessary in group 2 & 3 modes .
The top tether MUST NOT be used for non-ISOFIX installation.