8
Positioning the car seat
(continued)
2. Locate your vehicle’s top tether anchor points. These may be either located high up near a parcel
shelf (Type 1), or low down on the vehicle floor (Type 2) or on the back of the passenger seat
(Type 3).
WARNING! DO NOT attempt to use the car seat in group 1 mode with out a top tether. The
top tether MUST be used in group 1 mode.
Type 1
Type 2
Type 3
1. Squeeze the lever at the top of the seat and raise or
lower the headrest as needed. Adjusting the headrest
will automatically adjust the harness height.
Ensure the harness is at the correct height for your
child’s shoulders and not too high or too low.
Note:
The headrest/harness will only adjust as far as needed whilst in group 1 mode. Once the integral
harness is removed for groups 2 and 3 the headrest will adjust to a greater degree as needed.
Adjusting the headrest/harness height
