31
USE OF CONTROL PANEL
*1
When the main switch is turned at the ON position.
*2
The engine speed is controlled at 2800rpm.
*3
a. When the cooling water temperature reaches approximately 90
C or
higher, the overheat prevention device is actuated and stops the
engine.
b. Even if the cooling water temperature exceeds approximately120
C,
the cell motor can be run. But the engine prevention function is
actuated and the pump cannot be restarted.
*4
The engine speed is controlled at 6100rpm.
*5
TPS (Throttle position sensor)
MAT (Manifold air temperature sensor)
MAP (Manifold air pressure sensor)
WTS (Water temperature sensor)
*6
When the main switch is turned at the RUN position and before the engine
starts running.
Remedy
A: Replenish fuel.
B:
Inspect the amount of engine oil; if it is below the designated level,
replenish oil. If the designated oil level is satisfied, consult with the sales
representative.
･
Check the engine oil level before engine start. To confirm
the engine oil level correctly, keep the engine stopped for
more than 24 hours. After that, check the oil level.
C: Correct the cause of cooling water insufficiency, and then restart the
engine.
D: Correct the cause of abnormality by referring to “Chapter 16
TROUBLESHOOTING”, and then restart the engine.
E:
Turn the throttle dial to the low pressure side. There is a possibility of not
enough water remain in the suction water line.
F: Except of emergency, stop the engine and consult with your local sales
representative.
7
NOTE
１
１
２
２
３
３
４
４
５
５
６
６
７
７
８
８
９
９
10
10
11
11
12
12
13
14
15
16
17
18
13
14
15
16
17
18
19
19
