8
2.2 Setting up the Host Computer
1) Communication Conditions
It is required to match the set up values between the THIR-3000DM unit and the host
computer. Please refer to Section 7, conditions for RS-232C setup, for the default
settings.
2) Transmission Protocol
Data transactions between the reader and the host should be carried out in the prefixed
communication protocol. The host side computer should be provided with the required
software for this transaction control. For details of the required software, please refer to
Chapter 4.
・
The symbol data transmitted from the THIR-3000DM unit to the host computer is accepted
as a data receiving transaction.
・
Command signals are transmitted from the host to the THIR-3000DM unit. This is
required when setting up the operation from the host.
・
Image data can be transmitted from the THIR-3000DM unit to the host computer.
Unless specifically required, leave the picture image capturing function to be “Invalid” or
“Off” position. (Refer to attached sheet.)
2.3 THIR-3000DM Setting up the Operation
Default settings can be changed by sending command from host computer.
