21
Caution: Keep into account the amount of water you are going to empty in order to avoid
unnecessary surplus water on the site. Check at any time that the water flow out of the pool is
properly evacuated. Otherwise, the excess of water could cause damage to people as well as
material damage.
Always keep in mind the amount of water that will be drained in order to avoid any problem. It is
useful to have a drain close.
After all the water is drained, carefully disassemble the pool. In order to avoid any damage,
deformation or tear, disassemble the parts in the inverse order to the installation. Check all the parts
to make sure that they are perfectly clean and dry before storage.
Prior to storing, wash the liner with water and neutral soap that does not contain any chemical
products. To conserve the liner in optimum condition and avoid bad odors and humidity, wipe the
liner on both sides and dry it with a cloth or paper towel.
To make sure that the liner is not pierced, fold and store it in a separate place.
Keep the pool sections and parts in their original containers.
Keep the sections and parts of the pool in a dry and covered place.
If any of the pool elements are damaged, replace them as soon as possible with original TOI
accessories. See the address at the end of this manual.
ASSEMBLED POOL’S START UP
You should start up the pool at the beginning of the season. The proper procedure must be followed
to avoid problems during the period of the year that the pool is used.
a)
Check that your pool equipment (filter, skimmer, cartridges) are in good condition and
work correctly.
b)
If necessary, drain the pool and wash the liner with water and neutral soap or a
disincrustant product. The liner must be cleaned when the sun is low. Maintain the walls
and floor wet. Leave the product for a while and then rinse with water.
c)
When the liner is completely clean, fill up the pool.
d)
Begin the chlorination treatment. If it takes more than a day to fill up the pool, add the
chlorine gradually throughout this time.
e)
To maintain the water in optimum condition, analyze the water pH and make sure it is
between 7.2 and 7.6.
To reassemble your pool, follow the instructions beginning from the ‘INSTALLATION’ section.
For further consultations, please contact us:
TORRENTE INDUSTRIAL, S.L.
C/ Buitrera, s/n
46180 Benaguacil (Valencia)
SPAIN
Tel. +34.96.273.01.36
Fax. +34.96.273.05.45
E-Mail:
www.torrenteindustrial.com
