9
7. INSTALLATION OF BASE PLATE AND LOWER PLATE
a . G e nt l y l if t s t r ap (9) and insert four screws M5x15 (10) into the holes nearest the centre of
the pool. Make sure that the screw heads are pointing towards the ground. Place the strap back
on the ground and place the base plate (6) and then the lower plate (4) (as shown in photos 4, 5
and 6) onto the screws protruding through the strap. Place the nuts (11) onto the screws and
tighten in a random order. Be f or e t i ght en in g, c h ec k t h at t he bas e p lat e i s n ot at an
a ng le.
b . Repeat this proc ess on each s ide of t he strap and f or eac h strap.
8. INSTALLATION OF THE VERTICALS
a. Sit uat e one of t he v ert ic al c olumns (1) on t he lower plat e (4), f ix t he c olumn (1) t o
plat e “G” wit h s crews M5x15 (10) and corresponding nuts (11). Tighten the nuts in random
order (photos 7, 8, 9 and 10).
b. Check that there is a gap of approximately 2 mm underneath the flange at the lower end of each
vertical section, so that the lower “C” sections can slide in easily.
c. Repeat steps (a) to (b) for the other side of the pool.
photo 1
photo 2
photo 3
photo 4
photo 5
photo 6
photo
7
photo
8
photo
9
photo
10