Tokai LAR-91B, User Manual

24 

9. BLUETOOTH 

Before using the 

Bluetooth function

, your 

LAR-91B

 must first be paired with your Bluetooth device

.

Pairing is 

the term used when two Bluetooth devices are connected wirelessly for the first time. This allows the devices 

such as a mobile phone to see each other and sets up a one to one communication channel between both 

devices. Your Bluetooth device will keep the unique identification of your 

LAR-91B

 in its system. 

 
Press MODE button to enter in  BLUETOOTH  mode.  When  no  device  is  paired  to  the  car 

radio NO CON is displayed on the screen. 
 

1. Pairing 

Turn on Bluetooth mode of mobile phone, then select the function for Finding Bluetooth Device and enter it. 
After finishing finding, it will show the name of Bluetooth Device if found, select it and enter it, then it will show 
an interface that asks you to input password. Input the password 

0000

 and enter it. Then the LCD of the car 

audio system will display 

BT READY. 

 
IMPORTANT: Only one phone can be paired at a time with the LAR-91B. To pair another phone, 
disconnect the paired phone wait until NO CON is displayed on the LCD and follow the instructions 
of PAIRING described as above to match another device. 
 

2. Connection or disconnection 

A)

 Use mobile phone to do connection or disconnection 

1)

 In connection status, find the paired and connected Bluetooth Device, then press the disconnection button 

to do disconnection. 

2)

 In disconnection status, find the paired and disconnected Bluetooth Device, then press the connection 

button to do connection. 

B)

 When powering on (after Acc of the car was switched off), the unit will search for mobile phone, pair and 

connect. This will take about 10-15 seconds. 

Note: 

(1)

 Bluetooth icon appears on LCD only when in connection status. 

(2)

 In connection status: Mobile phone transfers to car audio player whenever a call takes place; Mobile phone 

transfers to car audio player whenever receiving a call. 

3. Calling when in connection status   

To make a call simply press the 

button and enter the number you wish to call using the mobile phone. 

When you’re ready to make the call press 

again, to end the call simply press 

 button

. 

To redial, press

, the last call number is displayed on the LCD, press 

  again to call. 

4. Accept/ Reject/ End Call   

 A)

 During ringing, press 

TEL button to accept the call. 

B)

 During ringing, press 

button to reject the call. 

C)

 During talking, press 

button to end the call.