18
SPECIFICATIONS:
Power source: AC 230V/50Hz
DC 12V UM2/"C" x 8pcs
Remote control: CR2025
Receiving bands: AM/FM
Tuning range: AM 540 - 1600 kHz
FM 88 -108 MHz
Power consumption: 28W
Output power: 2.5W x 2
TV system supportable: NTSC / PAL / AUTO
Operating Temperature Range: +5°C to +35°C
Continuous playing time: 120 minutes
Dimensions: 438.4mm(L)x262mm(W)x155mm(H)
Operating Humidity Range: 10 % to 75 %
Resolution: 640 x480 RGB
Disc supportable: CD, CD-R, CD-RW, DVD, DVD-R, DVD-RW,
DVD+R, DVD+RW
Support media format: DVD/MP3/MPEG4/KODAK PHOTO
CD/JPEG
Audio signal output:
1. DVD (linear audio)
(1) Frequency response: 20Hz-20KHz (48KHz sampling) &
20Hz-20KHz (96KHz sampling)
(2) S/N ratio: >45dB
(3) Wow and flutter: below measurable level
2. CD audio:
(1) Frequency response: 20Hz-20KHz
(2) S/N ratio: >45dB
(3) Wow and flutter: below measurable level
Specifications are subject to change without notice
DISC HANDLING PRECAUTIONS
y
Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints, dirt and scratches can
cause skipping and distortion.
y
Do not write on the label side with a ball-point pen or other writing utensils.
y
Do not apply benzene, thinners and liquid that prevents static electricity.
y
Be careful not to drop or bend the disc.
y
Install only one disc on the disc tray.
y
Do not try to close the disc tray when the disc is not installed properly.
y
Be sure to store the disc in its case when not in use.
TROUBLESHOOTING
If your DVD player does not seem to be functioning properly, check the items below before you contact an authorized service
center.
Symptom Check
Power does not turn on or
suddenly turns off.
y
Make sure the AC cord is securely plugged into AC socket and an AC outlet.
y
Turn the power off and then back on.
Remote control won't work
y
Check that the battery is inserted in the "+" and "-" direction properly.
y
The battery may be flat. Replace it with a new one.
y
Check that the signal transmission is directed at the remote control sensor on the DVD
player.
y
Remove the obstacle between the remote controller and remote control sensor.
No picture or sound
y
Check that the A/V cables are securely connected.
y
Check that the disc is a DVD, DVD-RW or AUDIO CD.
y
Do not use a disc that has scratches or dirt.
y
Check that the label-side of the disc is facing up.
y
The pick-up lens of the DVD player may be dirty. Contact the service center for lens
cleaning.
y
Check that the TV channel is set to VIDEO or AV if viewing with a TV.
y
Check image brightness and contrast settings.
y
Check if TV signal is strong or not.
No picture
y
Check that the LCD display is turned on.
No sound
y
Check the volume setting. If set to zero, turn up volume level.
y
Check that the headphones are plugged into the PHONES socket. Speakers cannot be
used with the headphones.
No picture and sound
y
Check that the battery is properly installed and AC cord is properly connected.
Distorted video or sound
y
Use a disc without scratches or dents.
Image is unclear or distorted
y
Check the direction, position and connection of the antenna.
No image or image is black
and white
y
Adjust color settings.
y
Check color settings.
