CardVisor Hardware Manual - Edge
Page 14 of 32
CardTool Removal
To remove the CardTool, either
use the thumb stop on the back
of the unit to gradually push it
out of the expansion slot or grab
the CardTool at the base of the
card slot and pull it away from
the Handspring Visor in the same
plane as the expansion slot. Try
not to grab the CardTool by the
top and bottom but rather each
side at the base of the card slot.
Grabbing the top and bottom of
the CardTool will generate a
force component, which will
increase the friction and make it
harder to remove. Note: If the
Visor is turned off, removal of the CardTool (or any other module) turns the Visor on.
Maintenance and General Care
•
The CardTool is not waterproof. Do not expose to rain or moisture
•
Do not drop the CardTool or subject it to strong impact.
•
Protect it from temperature extremes. Do not leave on the dashboard of a car
on a hot day and keep it away from heaters and other heat sources.
•
Do not store or use your CardTool in any location that is extremely dusty, damp
or wet.
•
Ensure the magnetic heads are occasionally cleaned with commercially
available magnetic cleaning cards.
•
Clean exterior of case with a dry lint free cloth and do not use abrasive cleaning
products.
