5.3 Coefficient, indication digits, and unit
5-8
2. Parameters for each channel are indicated.
Move the cursor with
[▲][▼][◄][►]
keys
to the item you want to change, and press
[ENT]
key. With
[F3]
key, you can go to
“Group setting”.
○ Setting coefficient
Enter values directly with ten keys. To
change +/-, press
[F1]
key. To move to
the input of index, use
[
◄][►]
keys.
After input values, press
[ENT]
key.
○
Setting indication digits
Move the cursor (reversed indication) with
[▲][▼]
keys to the indication digits you
want to set, and press [
ENT]
key.
○
Setting unit.
Move the cursor (reversed indication) with
[▲][▼][◄][►]
keys to the unit you want to
set, and press
[ENT]
key.
You can change pages of the list with
[F 2]
and
[F 3]
keys.
Before setting a coefficient, you need to understand relation between the
coefficient and indicated values. Especially, be careful when you set an
index. You can confirm relation between input values and indicated values by
the function mentioned in the page 10 of Chapter 5,
“Check of coefficient”.
Note
Summary of Contents for TC-32K
