5.7 Switching between Measure and Direct
5-14
5.7 Switching between Measure and Direct
There are two ways to display measurement values: “Measure value” from which the initial
value is subtracted
([M]
or
[m]
is indicated on the monitor), and “Direct value” from which
the initial value is not subtracted
([D]
is indicated on the monitor).
1. Move the cursor (reversed indication) with
[▲][▼]
keys on the Menu screen and press
[ENT]
key, or press
[2]
of ten keys, to go to
“ Measure/Direct mode”.
2. Move the cursor with
[▲][▼]
keys to the
setting of the channel you want to set, and
press
[ENT]
key. With
[F3]
key, you can
go to “Group setting”.
3. Move the cursor to either “Measure” or
“Direct” with
[
◄][►]
keys, and press
[ENT]
key.
4. The setting is fixed, and the display
returns to “Measure/Direct mode” screen.
Summary of Contents for TC-32K
