5.8 Automatic measurement
5-16
Note
3. Move the cursor (reversed indication) to
the step to be set with
[▲][▼]
keys, and
press
[ENT]
key or
[F1]
key.
4. Move the cursor to “Timer” with
[▲][▼]
keys, and press
[ENT]
key.
2. Move the cursor (reversed indication) with
[▲][▼]
keys on the Menu screen and press
[ENT]
key, or press
[1]
of ten keys, to go to
“Interval measurement”.
5. The setting is displayed temporarily as
shown in the left. Press [
ENT]
key again.
6. Move the input area with
[
◄][►]
keys, and
input values with ten keys or
[▲][▼]
keys.
To enter “Endless” (infinite) for the
number of repetitions, press
[F3]
key.
After inputting, press
[ENT]
key.
7. The operation has been set for Step 01.
The left screen shows the setting to
“measure 10 times at one-minute interval”.
To change the setting values,
press [ENT] key. To change the
setting content itself, press [F1]
key.
You can set from 1-second to
99-hour/59-minute/59-second at
1-second interval.
Note
Summary of Contents for TC-32K
