EN - 14
ASSEMBLY
Before using the fan for the first time, please proceed as follows: carefully unpack the appliance and all components and remove
all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of reach of children.
After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Assemble the fan in accordance with the instructions.
1. Remove the adjustment knob for the hinge and fixing bolt from the top part of the pedestal - fig. 1.
2. Remove the fixing bolt and ring for the base from the bottom of the pedestal - fig. 1.
3. Grab the foot and place the pedestal in the recess of the foot. While holding these parts, turn everything around, allowing
you to place the ring and then the fixing bolt. Properly fasten the fixing bolt, so that the foot is sturdy - fig. 2. Turn everything
around again and place the foot on a sturdy and flat surface.
4. Remove the adjustment knob for tilting from the fan's hinge point. Place the hinge point over the pedestal and find the hole
for the fixing screw. Screw the fixing screw in it, but not fully tight - fig. 3.
5. Place the fixing screw through the hinge and pedestal. Do take note of the square opening - fig. 4.
6. Tighten the fixing screw - fig. 5.
7. Mount the adjusting knob for the hinge on the fixing bolt - fig. 6.
8. Mount the adjustment knob for tilting to the fan. Determine in which position you want to use the fan and fix it by tightening
the adjustment knob.
The fan is ready for use.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
